IC695EDS001

The IC695EDS001 module is a GE Fanuc DNP3 outstation module. The integrated interfaces on the module include one serial port and 2 Ethernet ports.

The GE Fanuc IC695EDS001 module is a DNP3 outstation module for the RX3i PACSystems platforms. The IC695EDS001 module is an Ethernet module which is installed in the RX3i backplane and allows the RX3i system to act as an Outstation device on DNP3 networks where it can communicate with a maximum of 8 DNP3 masters. Communication interfaces on the module include a RS-232 port with a 9-pin female D-connector and two 10/100 Mbps Ethernet ports with a female RJ-45 interface. The RS-232 port can be used for network management. The integrated network switch supports auto-negotiate, crossover detection, speed, and sense functions. The supported Ethernet protocols include the LLA and TCP/IP protocols. One IP address and one MAC address are supported per IC695EDS001 module. A recessed restart button for the Ethernet firmware allows for the restarting of the Ethernet firmware without module power-cycling.